How to use a blackhead remover to get rid of acne

k

I know you have heard many times that you should never squeeze pimples due to the possibility of injuring your skin. However, when done properly and using the right tools, you can safely remove whiteheads  and blackheads with minimal to zero scarring.

Comedone extractor are small tools that usually resemble small rods and have loops attached to either end or contain sharp ends that are designed to pull out the core of the pimple without damaging your skin. They instantly get rid of whiteheads and blackheads  and are quite affordable.

We will go through a basic lesson on how to use this stool and the general steps that you can follow for a blackhead/whitehead free skin.

Now, lets get ready to attack these little monsters, first you need to clean your hands so dont transfer germs to your face.Next, put together the following ;

  1. A sterilized blackhead/whitehead extractor
  2. A warm wet towel or  a steamer( to steam your face)
  3.  Cotton wool
  4. Some spirit,medical alcohol or dettol.

Step one

Clean your face as you would normally do. Next,you need to soften your skin and  open your pores so that its going to be easy to extract the pimples. You can do this by either steaming your face bending over a basin of warm water with a towel over your head or by holding a warm face towel over  your face for a minute.Steaming allows the blackheads to get a little loser and come out more easily.For a hassle free, salon experience you can also use a professional facial steamer.

Step two

Apply your  sterilizer of choice to the area where the pimple is. Just soak a piece of cotton wool and gently apply to the inflamed area.This is to avoid infecting the area.

Step three

This is the most important part,so take care to use the extractor properly to avoid scarring.Place the loop of the extractor on the whitehead or blacked and gently  press down on it .Apply pressure to the sides of the blackhead if it  does not come out at the first attempt .The pressure  will force the blockage out as a plug.Repeat this for the other whiteheads or blackheads.

Step four

Cleanse your face , then apply toner and moisturizer.

Step five

Disinfect the extractor using a sterilizer or you can simply wash with hot soapy water. Allow it to air dry then store it away in a clean bag for the next use.

Five steps to instantly clear skin!

Back to blog